[. . . ] Technical Information Date: June 7, 2004 To: Technical Service Subject: Washer/Dryer Stand W1113, 1119, 1203, 1213, 1215 T1302, 1303, 1322C, 1323C, 1329C, 1403, 1405 Washer Stand Washer Stand Note: The washer/dryer stand is designed for use with washers and dryers only. Use for any other purpose may result in damage to the machine or personal injury. [. . . ] carpet) · Remove the washers feet · Using the threaded studs and nuts provided (M10), screw 2 nuts midway onto each threaded stud. · Screw the threaded studs (M 10) into the washer and tighten them see Fig. · Stand the washer upright · Install the washer stand rear panel using the 4 Torx screws provided see Fig. · Insert the 2 rubber bushings into the side holes of the washer stand. Dryer Stand Installation · Drain the unit, before laying it on its side. carpet) · Remove the dryers feet · Using the threaded studs and nuts provided (M8), screw 2 nuts midway onto each threaded stud. · Screw the threaded studs (M 8) into the dryer and tighten them see Fig. · Stand the dryer upright · Install the dryer stand rear panel using the 4 Torx screws provided see Fig. · Place the dryer into its final position being sure to line up the studs of the rubber bushings with the holes on the dryer stand. · Once the stands are together and in their final positions install a washer and nut onto each stud and tighten the nut see Fig. 6. [. . . ] · The drawer locks into position automatically when it is closed. · Open the drawer as far as possible then close it to check that it functions correctly [. . . ]